Cube 3 Support

CUBE 3 LEVEL PRINT HEADS (PROCEDURE)

Printing Tips: (NOTE:  Video calls for 1.3mm Square Allen Wrench which is incorrect. It should specify a
1.3mm Hex Allen Wrench.)

1.) It is recommended when you install a new print cartridge in the Cube 3 printer, you check to make sure the print heads are leveled, and run through the calibrations again.

Also, whenever cartridges are loaded/unloaded you have to always go through the “change cartridge” option in the menu to avoid furthering issues.

This video link will show you how to adjust the leveling of the print head nozzles:
Cube 3 Level Print Heads

How to do a Manual Calibration to make sure Gap (Z Gap) is correct (recommended on new printer install)

How to fix jammed Cube 3 Print Cartridge